Due to bucket elevator’s bucket is flat type ,it can not damage the layers ,but can not transport baking materials.
How to break the baking layers during bucket elevator’s running process and transport the crushed materials.
At this time, every 10 buckets in the bucket elevator can be installed with a toothed bucket; And the flat opening in front of the buckets can be Z-shaped, when the hardness of the sheet is not too large, the sheet can break. Let the subsequent bucket take out the broken material. Due to the overall strength of the bucket is not enough, if the phenomenon of accumulation occurs, the deformation is very serious, and the strength of the bucket is the most important. As the thickness of bucket elevator is 4mm,construction material is Q235-A, increasing the thickness will increase the weight of the buckets, thus increasing the load of other accessories of bucket elevator. Therefore, it is not appropriate to increase the strength of the buckets by increasing the thickness. In this case, an L50 rib can be added between the front and rear plate of the bucket elevator hopper, which is not only improving the strength of the hopper, but also does not significantly increase the weight of the bucket, and avoids the issues of bending and deformation of the buckets. www.wxconveyor.com