Home > Exhibition > Content
Correct operation and scientific maintenance of snake-shaped bucket conveyor
Apr 13, 2018

Prior to the feeding of the serpentine chain bucket conveyor, the scientific approach should be to allow the line to run for a period of time without load. After the equipment is in normal operation, the material must be added. At the same time, it must be ensured that the material is added evenly, and no sudden sudden heavy feeding or overload operation is required to avoid affecting the transport effect. .

 

In the absence of other special properties, it is required that the snake-shaped bucket and bucket conveyor should not be loaded and stopped. If it is necessary to stop, it is also necessary to stop feeding and empty all the materials in the equipment chain bucket before it can be stopped. Otherwise, the conveyor cannot be guaranteed. Accuracy.

 

When the serpentine bucket conveyor is in operation, it is not allowed to clean and repair the running parts nor to adjust the tensioner. For start-up after an emergency stop at full load, the material in the conveyor must be drained manually and then several times.

 

If several serpentine chain bucket conveyors are required to be connected, then one of the last unloaded materials should be started first and then moved forward one by one. The parking sequence is opposite to the starting sequence. Workers should also pay attention to constantly observe the running condition of the snake-shaped chain bucket conveyor, check whether the connection bolts are loose at each place, and whether the chain and hopper are in good condition. According to the use conditions and work environment of each factory, regular maintenance should be carried out.

 

If there is excessive accumulation of material in the tail of the snake-shaped chain bucket conveyor, it shall be removed; at the same time, regular attention shall be paid to adjusting the coil spring type tensioning device so that the chain of the snake-shaped chain bucket conveyor can ensure proper tension. The adjusting screws on both sides should be moved evenly so that the axis of the tail wheel and the center line of the conveyor are kept perpendicular. After adjustment, the nuts are used to lock.http://www.wxconveyor.com/


Products List